PCBA finishing

Conformal Coating Service for PCBA

In-line, not hand-brushed — automated spray, UV inspection and curing on our Shenzhen floor.

Automated sprayUV inspectionIn-line cureSame floor as SMT
Automated conformal coating for PCBA at XFPCB
Coating runs after electrical test and before packing on the same floor as SMT.

In-line, not hand-brushed

Hand brushing gives uneven thickness and a real risk of coating creeping into connectors, sockets and LCD contacts. We run a fully automated line — spray, UV inspection and curing in one pass — so thickness is consistent board to board and the cure is continuous rather than staged.

Coating chemistry

Industry-typical menu on our automated line:

  • Acrylic, polyurethane, silicone, and UV-curable coatings
  • Typical dry-film thickness 25–75 μm (zone and chemistry dependent)
  • Process can be validated to IPC-CC-830 when the program requires it

Confirm chemistry, thickness, and keep-outs on the RFQ — the choice changes both the masking plan and the cure profile.

What to send

Board file with keep-out areas marked, the environment the assembly will see, required coating thickness, and whether you need a UV-visible coating for your own incoming inspection.

Where this sits in the build

Coating runs after electrical test and before final packing, on the same floor as the SMT lines. Boards that fail test go to the rework area first; we do not coat a board we have not passed.

Request a Coating Quote

Send keep-out drawings, environment notes and thickness targets with your PCBA RFQ.

  • Mark connectors, test points and keep-out zones.
  • Name the chemistry preference if you have one.
  • State whether UV-visible coating is required for your incoming inspection.